Methownet BB

My system runs normally through the sequence of zones, but does not shut off when the watering is complete. Only one sequence is enabled..Suggestions or name of someone who can resolve this, thanks Bruce Herron Wolf Creek 509 341 9020

i have the same question please call 509-429-0022 at your convenience

If your irrigation system runs through all zones in sequence but doesn't shut off, the issue is likely with the valves or the controller. It could be a valve issue (stuck open, debris, or a faulty solenoid) or a controller problem (not sending the shut-off signal) If you can remove the affected valve, disassemble and reassemble it could fix the problem. Not likely its the controller. The valves are generally pretty simple to replace, lots of youtube video.

Sorry for the later response, Two day ago for whatever reason it started operating normally. There are two sections of my system not on the controller that run when ever the main valve is open. Now the go shut down when the system goes off, per normal.. Stuck Valve ?,, dunno, Bruce Herron Wolf Creek

Bruce. If you are on a well (most likely) you could be getting tiny bits of debris, sand, iron, who know stuck in the little vavle seats. Do you have strainer/filter on yous system before the valves?

Thanks for the suggestion, I suspect we have a strainer, I dont know where, The person who built the house left no documentation, and the previous owner was less than helpful, I will look around I suspect that it would be near the well head. b